Accessible menu

Page navigation



Transparency, Hints and Help.

The Cool Twister is a quality product made in Germany and is manufactured exclusively from high-quality material. Constant quality controls assure a consistent high quality standard. All components of the Cool Twister are exclusively produced in Germany.

Forum
Soon we will activate a forum here, where you can gather further information or ask your own questions.

Easy Question- You ask, we answer 
Ask a question and you will receive the answer within 12h. Read more in the section Service.

 
Frequently asked questions answered quickly.

Why is it so important to hit the right temperature?

The baby food manufacturers explicitly advert to stir in your baby food at the recommended temperature. This temperature can vary, depending on the kind of starch used or the temperature sensitive ingredients, and may be 40°, 50° or 60°.
In either case the prescribed temperature is the ideal balance between a lump free dissolving of the baby food and the preservation of its ingredients.

How can you adjust the temperature?
Just open the red sealing screw and fill the Cool Twister with water (from the tap). The amount of water you add defines the temperature to which the boiling water will cool down. 450 ml for 40°C, 280ml for 50°C and 180ml for 60°C.
Close the sealing screw. Finished.
bt The cooling element of the Cool Twister System contains a
   cooling coil, which is surrounded by water.
bt Depending on the amount of this water, you can freely adjust
   the desired target temperature (“lots cools lots- less cools less”).
bt While the 100°C hot water runs through the coil it transfers the
   undesired heat to the cooling water via the coil.
bt The cooling water is never in contact with the water for the baby
   food, since there are two separate circuits.
bt Between the applications the Cool Twister is always stored in the
   refrigerator (with its size of 10 x 11,5 cm it even fits into the side
   shelf.
 
How do you clean the cooling element?

1x/ week the cooling water should be exchanged and the entire cooler should be cleaned in a boiling water bath (please use the detailed instruction manual for further information)

How do you decalcify the Cool Twister?
The Cool Twister does not calcify like a coffee machine or a kettle. Calcium carbonate favours to settle on the heat source.
However the Cool Twister is practically the opposite.
When using very hard water however, some sediments can settle after a period of 2-3 months. In this case pass organic citric acid or diluted vinegar (1:1 / water:vinegar) through the cooling element several times. Afterwards rinse it again thoroughly.

How can I use the Cool Twister on the way?
At home the Cool Twister is stored in the refrigerator when it’s not in use. Its function is only marginally affected when cold water is filled into the cooling element directly from the tap.
… and you can get cold water from the tap almost everywhere. 

Can the Cool Twister also cool down coffee or tea?
Basically yes. The temperature can be chosen individually between approx. 40 and 80° C. However, the Cool Twister should not be used for the preparation of baby food afterwards because it may be contaminated by coffee or tea residues.
Hint: pass a small amount of water through after the coffee or tea ran through and clean the Cool Twister 1-2x / month by rinsing the coil with a denture cleaning tablet dissolved in water.